Service Bulletin K-011: Pinball Magic Update
To update the interlock plate and switch bracket position on prototype PINBALL MAGIC games. This is needed in order to be able to use kits k-008-2 and k-008-5.
Parts list
- Template, switch bkt drill holes Part# PM00143
- Coin door switch actuator Part# MT00329
- Instruction sheet Part# PM00144
Serial numbers affected
Serial numbers PB100001 to PB100040 will require this kit to be used in conjunction with kits, K-008-2 and K-008-5.
Tools needed
- 1/4" nut driver
- 11/32" nut driver
- Center punch
Procedure
- 1. Inventory kit part against the list above. Please contact your local CAPCOM
distributor regarding any missing or damaged parts.
- Turn the power to the game off, and unplug it from the wall.
- Remove the interlock bracket from the inside of the cabinet.
- Align the template, part # PM00143, to the inside left of the cabinet coin door
opening. The bottom of the template should be in line with the bottom of the
coin door opening.
- With your center punch, mark the cabinet in the two designated areas.
- Install the switch bracket, part # MT00321-2, which is provided in kits
K-008-2 and K-008-5.
- With your 11/32" nut driver, remove the interlock plate from the coin
door.
- Install the new switch bracket, part # MT00329.
- Proceed with the installation instructions of kit K-008-2 (disregard steps 17-20) or
K-008-5 (disregard steps 19-21).