K-010 Dot Matrix Display Upgrade Kit

Parts needed Serial numbers affected Tools needed Reason for kit

We have gone from a display with an on board power supply to one that has a separate power supply PC board.

Procedure
  1. Check to ensure that all parts are present, and intact. If there are any missing or damage parts please contact your local CAPCOM distributor.
  2. Turn the power to the game off, and unplug it from the wall.
  3. Locate the key to the backbox. Insert the key into the lock at the top of the backbox and turn it fully clockwise. Lift up on the backglass and swing it out towards the front of the game. Carefully remove the backglass and set it aside in a safe place.
  4. Open the lamp door by lifting the latch, and swing it completely open.
  5. Open the dot matrix display panel by pushing the two latches, located above the speaker enclosures, out towards the sides of the backbox.
  6. Disconnect the ribbon cable and power supply cable from the display. This power supply cable should now be removed from the game and discarded. It connects from the dot matrix display to ‘J6’ on the main power supply PCB. At this point cable ties will need to be cut in order to remove the cable. Do not re-clamp the wires at this point.
  7. Remove the four (4) screws that secure the metal cover for the display, and set the cover (with the CPU PCB still attached) in the back box.
  8. Remove the old dot matrix display and replace it with the new one.
  9. Replace the metal cover, and screw it down. Make sure that the speaker wires are not pinched under the cover when you replace it.
  10. Place the display power board on the four standoffs to the left of the CPU. Make sure that the PCB is oriented in such a way that connectors, ‘J1’ and ‘J2’, are on the side of the PC board that is closest to the backbox wall at this point (see FIGURE 1). Secure the display power supply board to the standoffs with the four (4) screws provided.
  11. Attach the display power cable from connector ‘J2’ on the dot matrix power supply board to connector ‘J4’ on the dot matrix display.
  12. Connect the small ribbon cable from the CPU PCB to connector ‘J5’ on the display.
  13. Attach the main power cable to connector ‘J1’ on the display power board. Connect the opposite end to the power board at connector ‘J6’.
  14. Verify that all connectors are in the correct location, and that they are all seated properly.
  15. You will now want to make sure that the cables you have used are routed in such a way that they will not get pinched when the dot matrix display panel is closed. Use cable ties to secure the wires in place.
  16. Close and latch the dot matrix display panel and the backbox lamp door. Replace and lock the backglass in place.
  17. SMOKE TEST! Plug in the game and turn it on. You should now have a fully functional display. If the display is not working at this point, turn the game off and verify that all connectors are in the proper locations. If the display is still not working contact your distributor for further help.